Heated Tank Specialists
We design and build electrically heated industrial equipment and accessories.
Sta-Warm engineers have the experience and know-how to design and build the exact
installation you need. A proposal, based on production data you supply, will
be submitted without obligation.
Sta-Warm also heats spray guns and hoses for use with pressurized tanks and numerous other types of outlets or dispensers which you may require.
For conveying melted compound from a central tank to points of use, the
Sta-Warm Method permits rigid pipe to be satisfactorily heated in order
to convey material many feet without a critical drop in temperature. Sta-Warm
has supplied up to 800 feet of electrically heated pipe for a single installation.
When above mentioned equipment and accessories are used in a properly engineered
combination, it may be safely said that any practical amount of melted
compound can be supplied continuously to any point in you plant where production
requires its use. Sta-Warm engineers have the experience and know-how
design and build the exact installation you need. A proposal, based on
production data you supply, will be submitted without obligation.
||Here is a heated outlet, a gate
valve, which is readily heated by the Sta-Warm Method and automatically
controlled. It is an essential accessory to many installations which,
unless heated, might cause compound to freeze in the outlet.
||Here is another popular type of outlet,
a needle valve, for dispensing melted compound in a small stream or
a few drops at a time.
||Here's the Sta-Warm heating element
which is wrapped closely and uniformly around sidewalls and bottom areas
of any size or shape of tank or pot you may require for melting compounds
||Here color is used to identify two heating
circuits as applied to one tank. In actual practice any practical number
of circuits are possible to provide the necessary amount of heat, and
as many zones of heat, as a particular installation may require for greatest
efficiency and operating economy.
||The result is uniform heat throughout, without
hot spots to burn the contents and without cold unmelted lumps that clog
outlets or slow down production.
||Accurate control of heat is accomplished with
variable thermostats, 3 heat switches or single on-off switches. Accompanying
chart of 24 hour test suggests how closely temperatures can be controlled
by the Sta-Warm Method. It is not unusual to design a unit which holds
to 5 or 3 or even one degree Fahrenheit, plus or minus.
||Does the compound formula you use require
agitation to maintain the mix or to keep solids in suspension? Sta-Warm
furnishes three basic types of power agitators. Any can be modified to
meet your needs.